Automotive test benches with integrated force and torque measurement technology

Our sensors are not mounted externally, but rather structurally integrated – precisely at the point where forces actually act.
This results in realistic measurements without parasitic influences from additional adapters or measuring frames.
The sensor geometry is mathematically optimized for your load paths.
This improves linearity, decoupling, and signal stability.
Ideal for engine, transmission, axle, and structural test benches.

Test benches run continuously for thousands of hours – our sensors are built for this.
Designed for oils, coolants, dust, vibrations, and temperature fluctuations.
Optionally available with IP-protected housings up to IP69K.
Mechanically and electrically optimized for long-term stability over millions of load cycles.
Once integrated – years of low-maintenance operation.

Our sensors integrate the measuring element and electronics directly into the test bench installation space.

Signal conditioning, amplification, and filtering are performed within the sensor housing – without external amplifiers or additional space requirements.

Thanks to our expertise in analog electronics and integration, noise-stable signals are generated even at high sampling rates and under dynamic test bench conditions.

The result is a robust, ready-to-install measurement solution that integrates seamlessly into structural components, adapters, or clamping devices.

We speak the language of your test bench and development engineers.
Joint analysis of CAD data, load assumptions, and installation situations.
Early feasibility assessment instead of later corrections.
A personal contact person throughout the entire project.
Not a supplier – but a technical partner on equal footing.